As opposed to a sit-down unit, the stand-up lift truck unit is totally different to utilize. The way at which you lift loads and your movements are really different. If you do not have proper training for using a stand-up model, you can potentially cause harm co-workers or to yourself. When operating a stand-up model, you must follow the proper safety regulations. There are several basic operating standards which should be met when operating a stand-up unit.
When starting, stand up on the forklift in order to get a feel for the controls and the steering knob. The steering is handled using the knob steering plate rather than a steering wheel. Remember that this knob moves really fast, therefore, you should get used to moving it carefully in order to be certain not to over steer. The horn is situated on the control handle, like with the control for forwards, backwards and the fork movement. The floor pedal allows the machine to move.
When you are set to begin, turn the key to start the equipment. Be sure that your forks are not extended. If you are moving around the floor, the forks should be pointed slightly upwards. Do not drive with the forks in their extended position. If you are moving forward, move the control handle forward and in order to make the lift move forward, step on the pedal. If you are backing up, be certain to beep your horn in order to warn those around you. Look behind you before stepping on the pedal in order to make sure the path is safe and clear. After that, while stepping on the pedal, pull the control handle towards you. Stay alert and focused and make sure that you are operating in a safe way at all times.
When it comes to turning corners, turn your steering knob in the direction you need to go while keeping your foot on the power pedal and your hand on the control handle. When turning right, the steering knob would move in a clockwise direction during forward travel. If you are turning left, your steering knob would go in a counter-clockwise direction.
The stand-up models take some getting used to, especially if you have just utilized sit down models. If you take some time to figure out the equipment and with some training, you can efficiently and quickly handle loads in little time.