Most of the time, businesses would spend a lot of money to buy their lift trucks. It is vital, therefore to take good care of your machinery to protect your investment into the long run. It is a great idea to know the procedures that are carried out during maintaining and taking care of this equipment.
By starting up the forklift and listening closely how it works is one of the best ways to tell how good the engine is running. Like for instance, if there are any misses or knocks, the machinery is faulty and this should raise some concerns. Furthermore listen carefully for any squealing sounds which come from the belts since these noises will provide you with a lot of information.
When doing maintenance, some of the main components you would need to pay attention to include the safety warning devices, horn, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs should be replaced as soon as they are noticed. It is also vital to check the wiring.
When the above components have been inspected thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each cell of the battery needs to be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be frequently replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker to be able to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle needs to be performed. If there is a grease fitting on the axle make sure to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Afterwards, inspect every other part of the machinery including the wheels. If any kind of issue or fault is detected, be certain to address it immediately in order to make sure the machine is running at its safest and optimum levels.